Updated November 2026
One board birdhouse plans give you a complete nest box from a single 1×6 cedar board, with no leftover scrap and only a handful of cuts. This guide covers the cut list, the assembly order, and the hole size and drainage details that keep birds safe. You can finish the build in an afternoon with basic hand tools.
Cut List and Materials for One Board Birdhouse Plans
A standard 1×6 cedar board, about 6 feet long, yields every part for this design when you cut it carefully. Cedar resists rot and does not need paint, which suits a nest box better than pressure-treated lumber. Manufacturers of exterior wood typically recommend exterior-grade screws, and stainless or coated deck screws avoid rust stains.
Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).
- Front panel: 5 1/2 in. x 8 in. (includes top overhang)
- Back panel: 5 1/2 in. x 11 in.
- Side panels (2): 4 1/2 in. x 8 in. with 15-degree top bevel
- Floor: 4 1/2 in. x 4 in.
- Roof: 7 in. x 6 in. (two pieces cut from the remaining board)
- Hardware: 1 1/4 in. exterior screws, 1 1/4 in. galvanized nails, waterproof wood glue
Build Steps: Cutting and Assembling the Box
Start by ripping the 1×6 board to its actual width of about 5 1/2 inches, then crosscut each part to length. Mark the 15-degree bevel on the side panels so the roof will shed water. Keep the cut edges square; a box that is out of square will fight you during assembly.
Drill the Entrance Hole and Drainage
Drill the entrance hole in the front panel 1 1/4 inches from the top edge, centered side to side. For chickadees and wrens, a 1 1/8-inch hole keeps out starlings and larger birds. Drill four 1/4-inch drainage holes in the floor and two small ventilation holes near the top of the back panel.
Assemble the Walls and Floor
Glue and nail the sides to the back panel first, then attach the floor so it sits between the sides with the bottom edge flush. Pre-drill every screw hole to prevent splitting cedar. Attach the front panel last so you can reach inside to check fit and alignment.
Finishing and Mounting Your Nest Box
Attach the two roof pieces with a slight overhang to protect the entrance from rain. Leave the interior unfinished and unpainted, since birds need natural wood and no chemical residue. Mount the box 5 to 10 feet off the ground on a pole or fence post, facing away from prevailing winds.
Common Mistakes to Avoid
- Skipping drainage holes, which lets moisture pool and rot the floor.
- Using treated lumber or painting the interior, both of which can harm nesting birds.
- Making the entrance hole too large for the target species.
- Mounting the box in direct afternoon sun, which can overheat nestlings.
- Failing to open the box for cleaning once a year after the nesting season.
Recommended Gear
- Exterior deck screws: Coated screws resist corrosion and hold cedar without splitting it. View on Amazon
- Hole saw set: A bit set lets you drill clean, accurate entrance holes of several sizes. View on Amazon
- Clamps: Clamps hold panels square while glue cures during assembly. View on Amazon
FAQ
What size board do I need for one board birdhouse plans?
A 1×6 cedar board about 6 feet long provides enough material for the full box, roof, and floor. Cedar is preferred because it resists weather without chemical treatment.
What entrance hole size should I use?
A 1 1/8-inch hole suits wrens and chickadees, while 1 1/2 inches suits bluebirds. Matching the hole to your target species keeps out larger competitors.
When should I clean out the nest box?
Clean the box once after each nesting season, ideally in late fall or early winter. Remove old nesting material and check for pests, and consult a local wildlife agency for species-specific guidance.
Conclusion
With one 1×6 cedar board and a few careful cuts, you can build a durable nest box in an afternoon. Pay close attention to hole size, drainage, and mounting height, since those details matter most to nesting birds. Build with the plan above, and your box will serve birds for many seasons.
Related reading
- One-Board Birdhouse Plans Free: Build a Cedar House in One Afternoon
- Wren Birdhouse Plans Free: Build a Cedar House in One Weekend
- Western Bluebird Birdhouse Plans: Build a Nest Box in One Afternoon
- Plans for a Bluebird Birdhouse: Build One in a Weekend
- Octagon Birdhouse Plans Free: Build One in a Weekend
