Updated November 2026

Cardinal birdhouse plans free printable guides give you dimensions, a cut list and assembly steps you can follow with basic tools. A well-built cardinal box can be finished in a single weekend. The key is an open-front design, because northern cardinals build open cup nests in dense shrubs and will not use an enclosed box the way wrens or bluebirds do.

Understand What Cardinals Need From a Nest Site

Cardinals are not cavity nesters, so a traditional birdhouse with a small entry hole will sit empty. Instead, they want a sheltered shelf or platform with overhead cover and a clear view of their surroundings. Plans built around an open front, roughly 6 to 8 inches wide and 6 inches tall, mimic the natural shrub setting they prefer. Mount the box about 5 to 10 feet high in a dense evergreen or thick shrub, and keep it away from busy feeders so the birds feel secure.

Shopping for one? See our guide: 3 Best Free Printable Octagon Birdhouse Plans Frees (2026): Our Picks.

Before you cut anything, print the plan at 100 percent scale and confirm the scale bar matches a ruler. Many printable sheets are scaled to fit a letter-size page, which shifts every dimension. Measure one known line on the printout, such as a 12-inch side panel, to verify. Use the cut list as your reference and mark each piece on the board before cutting.

Materials and Tools You Will Need

  • One 1×6 cedar, pine or fir board about 6 feet long, or enough for the panels listed on your plan
  • Exterior-grade wood glue and 1-1/4-inch exterior screws or galvanized nails
  • Miter saw or hand saw, drill with bits, tape measure and combination square
  • Sandpaper in 120 and 180 grit, plus exterior primer or a water-based finish
  • Stainless steel or galvanized hanging hardware and a short wire or bracket

Cut, Assemble and Finish the Box

  1. Cut all panels to the lengths on the cut list. Label each piece on its back side.
  2. Sand the cut edges and faces before assembly, since the inside is hard to reach later.
  3. Glue and screw the two side panels to the back panel, keeping the top edges flush.
  4. Attach the floor with a small gap of about 1/4 inch at the corners so rainwater can drain.
  5. Fit the roof so it overhangs the front by 2 to 3 inches. Pre-drill every screw hole to prevent splitting.
  6. Apply a finish to the outside only. Leave the inside bare and unsealed.
  7. Mount the box with the front facing away from prevailing wind, screwed into a branch or post.

Common Mistakes to Avoid

  • Building an enclosed box with a hole. Cardinals will ignore it, so keep the front fully open.
  • Using treated lumber or painting the inside, since fumes and residue can harm nesting birds.
  • Placing the box in full sun or in an open yard with no cover nearby.
  • Skipping the floor gaps, which trap moisture and cause the bottom to rot.
  • Mounting the box too low. Cardinals prefer some height and shelter from ground predators.
  • Exterior wood glue holds joints through seasonal swelling and shrinking. View on Amazon
  • Stainless steel exterior screws resist rust and stay tight in outdoor wood. View on Amazon
  • A digital angle finder helps you set the roof pitch accurately. View on Amazon

If you want a larger or different style of box, the Free Cardinal Birdhouse Plans: Build a Cardinal-Sized Nest Box in One Weekend guide covers similar dimensions. For a broader selection of printable designs, see Free Birdhouse Plans PDF: 6 Printable Designs With Cut Lists. Beginners may also find Free Printable Birdhouse Plans: Step-by-Step Guide for Beginners useful for learning the basic joinery.

FAQ

Will cardinals use a regular birdhouse with a round hole?

Usually not. Cardinals nest in open cups in shrubs and dense vines, so they rarely use enclosed boxes with entry holes. An open-front design is the best bet.

What size should a cardinal nest box be?

Most printable plans use an interior of roughly 6 to 8 inches wide and 6 inches tall, with a fully open front. Check your specific plan for exact dimensions.

Where should I hang a cardinal box?

Mount it 5 to 10 feet high in a dense evergreen or thick shrub, facing away from prevailing wind and away from heavy foot traffic.

Conclusion

Printing accurate cardinal birdhouse plans free printable sheets, checking the scale and following the cut list will get you a solid nest site. Keep the front open, avoid treated wood inside and place the box in cover. With those details right, a cardinal box is a practical weekend build.

Audrey Hayes

About Audrey Hayes

Audrey Hayes is part of our editorial team and reviews and edits our woodworking guides, checking product details against manufacturer specifications and owner feedback.