Updated November 2026

Simple birdhouse woodworking plans give you a sturdy nest box you can build in an afternoon with basic tools. This guide covers a classic bungalow-style house made from one 1×6 board, with a cut list, assembly order and the details that keep birds safe and the box easy to clean. The dimensions below suit small cavity nesters such as wrens, chickadees and bluebirds.

Materials and Cut List

Use untreated cedar, pine or cypress. Cedar resists rot and does not need paint, and paint or stain should never go on the inside of the box. Start with a 1×6 board about 6 feet long, roughly 3/4 inch thick, which gives you enough stock for every piece below.

Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).

Part Qty Dimensions (inches)
Front and back 2 5 1/2 x 9
Sides 2 5 x 8 1/2 (angle the top edge to meet the roof)
Floor 1 4 x 4
Roof 2 4 x 6 (overhang 1 inch past front and back)

Mark the entrance hole on the front piece. A 1 1/8-inch hole suits wrens and chickadees, and a 1 1/2-inch hole suits bluebirds. Drill it about 6 inches above the floor so predators have a harder time reaching in.

Assembly Steps

Assemble the box with exterior-grade wood glue and 1 1/4-inch galvanized or stainless exterior screws. Pre-drill every screw to prevent splitting.

  1. Cut all parts to the sizes in the table, then sand the outside faces and edges lightly.
  2. Drill the entrance hole in the front piece and check its center height.
  3. Attach the floor between the two side pieces, then fasten the front and back to the sides. Leave the floor slightly recessed or drill four 1/4-inch drainage holes in it.
  4. Add the roof pieces with a slight slope so water runs off the front. Use hinges or a single screw on one side if you want the roof to open for cleaning.
  5. Drill two 1/4-inch ventilation holes near the top of each side, then mount the house with a backing board or a pole.

Mounting and Placement

Hang the box 5 to 10 feet above ground in a spot that gets morning sun and some afternoon shade. Face the entrance away from prevailing winds and away from heavy brush where cats can wait. Clean the box after each nesting season by removing old nesting material, which also helps prevent parasite buildup.

Common Mistakes

  • Using treated lumber or painting the interior, which can harm nestlings.
  • Skipping drainage holes, which lets water pool on the floor.
  • Making the entrance hole too large, which lets in starlings and house sparrows.
  • Installing a perch on the front, since it gives predators a foothold and is not needed by cavity nesters.
  • Forgetting the roof overhang, which lets rain drive into the entrance.
  • Exterior wood glue: Holds joints firm against moisture swings in outdoor boxes. View on Amazon
  • Stainless exterior screws: Resist rust far better than standard screws in damp conditions. View on Amazon
  • Hole saw set for wood: Cuts clean entrance holes of the sizes you need without tearing the grain. View on Amazon

FAQ

What is the best wood for a simple birdhouse?

Cedar is the most common choice because it resists rot and insects without chemical treatment. Untreated pine and cypress are also good options.

What size entrance hole should I cut?

A 1 1/8-inch hole works for wrens, chickadees and titmice, while a 1 1/2-inch hole suits bluebirds. Smaller holes help keep out larger competing birds.

When should I clean out the birdhouse?

Clean it after each nesting season, once the birds have left and before new nesting begins. Wear gloves and a dust mask when removing old material.

Conclusion

A simple birdhouse made from one 1×6 board can be built in an afternoon with a few basic tools. Follow the cut list, keep the interior unfinished, and mount the box in a safe, sheltered spot. With a little care, it can host nesting birds for many seasons.

Colin Foster

About Colin Foster

Colin Foster is part of our editorial team and reviews and edits our woodworking guides, checking product details against manufacturer specifications and owner feedback.