Updated November 2026
DIY church birdhouse plans give you a steeple-style nest box you can build from a single board of cedar or pine. This guide walks through the cut list, the assembly order, and the entrance and ventilation details that keep birds safe and the box usable for years. Most builders finish the core box in an afternoon, with the steeple and paint taking a little longer.
Materials and Cut List
Use rough or smooth cedar, pine, or cypress at least 3/4 inch thick. Avoid pressure-treated lumber, painted boards, and plywood with glue that may release fumes. The dimensions below are for a box about 8 inches tall with a 4-inch-square floor.
Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).
- Two front and back walls: 3/4 x 5-1/2 x 8 inches (one with entrance hole cut later)
- Two side walls: 3/4 x 4 x 8 inches, angled top edge at roughly 30 degrees
- Floor: 3/4 x 4 x 4 inches, with four 1/4-inch drain holes
- Roof panels (two): 3/4 x 4 x 6 inches, cut to a 30-degree bevel along one long edge
- Steeple: 3/4 x 3 x 6 inches, tapered to a point, plus a 1 x 1-inch cross-section base
How to Build the Church Birdhouse
Start by cutting the entrance hole in one front wall before assembly. The hole size depends on the species you want to attract, so check the species chart in the next section first. Drill the hole with a Forstner bit, then sand the edges smooth so no bird gets a splinter.
Assemble the Box
- Attach the side walls to the floor using exterior wood glue and 1-1/4-inch galvanized or stainless exterior screws. Keep the floor flush with the bottom edges.
- Attach the back wall, then the front wall with the entrance hole. Leave the front removable for cleaning if you plan to add a hinged panel or screws instead of nails.
- Cut a 1/4-inch gap along the top of both side walls so air can move through the eaves. This is your ventilation.
Add the Roof and Steeple
Fasten the two roof panels so they meet at the peak with a small overhang of about 1 inch on each eave. Leave a 1/4-inch gap at the peak for ventilation. Build the steeple separately: taper the tall piece to a point, glue it onto the base, and screw the base to the top of the roof from inside the box for a clean look.
Hole Sizes and Placement by Species
Entrance size controls which birds can use the house and which ones get pushed out by larger species. Use this table as a starting point and confirm details with a local extension office or Cornell Lab of Ornithology resources.
| Bird species | Entrance hole diameter | Floor height above ground |
|---|---|---|
| House wren | 1-1/8 inches | 5 to 10 feet |
| Carolina chickadee | 1-1/8 inches | 4 to 8 feet |
| Eastern bluebird | 1-1/2 inches | 4 to 6 feet |
| Tree swallow | 1-9/16 inches | 5 to 15 feet |
Mount the box on a pole or fence post facing away from prevailing winds and away from direct afternoon sun. Plan for predator guards on posts if cats or raccoons are common in your area.
Common Mistakes
- Using pressure-treated wood or stained boards with unknown chemicals.
- Sealing the roof gaps, which traps heat and moisture inside the box.
- Drilling the entrance too large, letting starlings or sparrows take over the nest.
- Skipping drain holes in the floor, so rain pools and chills nestlings.
- Painting the interior, since fumes and flaking paint are unnecessary risks.
Recommended Gear
- Forstner bit set: Clean, flat-bottomed holes for entrance cuts without splitting the front wall. View on Amazon
- Exterior wood glue: Holds joints well in outdoor conditions when paired with screws. View on Amazon
- Stainless exterior wood screws: Resist rust and keep the box together through seasons of rain. View on Amazon
FAQ
What wood is best for a church birdhouse?
Cedar is the most common choice because it resists rot and does not need paint or stain. Untreated pine works too if you seal the exterior with a nontoxic finish.
How high should I mount the birdhouse?
Most small songbirds prefer a floor between 4 and 10 feet off the ground. Check the species needs before you choose a height.
Do I need to clean the birdhouse?
Yes. Remove old nesting material once a year after the nesting season ends, which helps reduce parasites and makes the box ready for the next pair.
Conclusion
With the cut list, the right entrance size, and a clean assembly, your DIY church birdhouse will be ready for the next nesting season. Build it from cedar, keep the ventilation gaps open, and mount it where the birds you want can reach it safely. For a larger project or a different style, see related builds on the site.
