Updated November 2026

Barred owl birdhouse plans call for a larger box than most backyard designs, with a floor of roughly 16 by 16 inches, an interior height near 24 inches and a 10-inch round entrance. This guide gives you the dimensions, the cut list logic and the assembly order so you can build one box in a single weekend. Barred owls do not carry their own nesting material, so the box needs enough floor space and a rough interior surface for the eggs.

Confirm the Dimensions Before You Cut

Barred owls are large birds, and a box sized for wood ducks or kestrels will not work. Plan around a floor of 16 by 16 inches, a 24-inch interior height from floor to ceiling and a 10-inch-diameter entrance hole centered about 20 inches above the floor. Use 3/4-inch exterior plywood or 3/4-inch cedar boards for every panel. Thinner stock flexes under the weight of a nesting bird and invites weather damage at the seams.

Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).

For a comparison with smaller boxes, the Large Birdhouse Plans Free: 4 Builds for Owls, Kestrels and Wood Ducks guide shows how dimensions shift across species. The Screech Owl Birdhouse Plans: Free Cut List and Build Steps article covers a much smaller owl box you can compare against.

Cut the Panels and Pre-Drill

Cut the following pieces from 3/4-inch plywood or cedar, then label each one on the inside face:

  • Two side panels: 16 1/2 inches tall at the back, 24 inches at the front (sloped top), 16 inches wide
  • Front panel: 16 by 26 inches, with the 10-inch entrance hole cut before assembly
  • Back panel: 16 by 26 inches, extended 2 inches at the top for mounting
  • Floor: 16 by 16 inches, with four 1/4-inch drain holes
  • Roof: two pieces, 10 by 18 inches each, set at a slight pitch with a 1-inch overhang on each side

Drill pilot holes before screwing anything together. Cedar and plywood both split near the edges if you skip this step.

Assemble the Box in the Right Order

Attach the floor to the side panels first, then add the front and back. Keep the front panel flush with the floor so no lip traps water. Screw the roof on last, using hinges or a removable top so you can clean the box after the nesting season. Plan for an annual clean-out in late summer, since leftover droppings and debris make the interior unhealthy for the next occupant.

Seal the exterior with a water-based exterior stain or no finish at all. Do not paint the inside. Leave the interior rough, because barred owls and their chicks need grip on the walls, and a rough surface helps the young climb toward the entrance when they are ready to leave.

Mount the Box Safely

Mount the box 12 to 30 feet off the ground on a mature tree trunk, facing away from prevailing winds and open to the north or east if possible. Use a nail or screw through the back mounting tab, and add a second anchor at the bottom if the box sways. Avoid mounting it where raccoons or cats can climb to the entrance. A metal baffle or a smooth trunk section below the box helps keep predators out.

Tips and Common Mistakes

  • Do not make the entrance smaller than 10 inches. Owls will reject a tight hole, and the box stays empty.
  • Skip perches under the entrance. Barred owls do not need them, and they give raccoons an easy approach.
  • Check the floor drain holes each spring. Blocked drainage leads to wet nests.
  • Do not fill the box with wood shavings. Barred owls use the bare floor, and bedding can trap moisture.

A 1/4-inch drill bit set makes the drain holes and pilot holes quicker to produce. View on Amazon

A cordless drill driver with a set of exterior-rated wood screws keeps the assembly tight without splitting cedar. View on Amazon

A hole saw in the 10-inch range cuts the entrance cleanly. View on Amazon

FAQ

What size entrance hole do barred owls need?

Plans for barred owls usually call for a 10-inch-diameter entrance. A smaller hole may keep the birds from using the box at all.

How high should a barred owl birdhouse be mounted?

Mount it between 12 and 30 feet off the ground on a sturdy trunk. Higher placement helps keep ground predators away.

Should I add nesting material to the box?

No. Barred owls typically lay eggs on the bare floor, so adding shavings or straw can trap moisture and cause problems.

Conclusion

These barred owl birdhouse plans give you a box with the right floor space, entrance size and mounting height for a large owl. Cut and label every panel before assembly, and keep the interior rough and unpainted. Clean the box every late summer, and check the mounting each spring to keep it safe.

Audrey Hayes

About Audrey Hayes

Audrey Hayes is part of our editorial team and reviews and edits our woodworking guides, checking product details against manufacturer specifications and owner feedback.