Updated November 2026
Birdhouse condo plans free give you a single structure with several separate nesting compartments, so one post can house a whole colony of swallows, chickadees or wrens. This guide walks through a simple six-unit cedar condo, with a cut list, the key dimensions that matter for each species and the assembly order. You can finish the build in a weekend with basic tools.
Choose the Right Condo Design for Your Birds
Condos work best for cavity nesters that tolerate close neighbors, such as tree swallows, violet-green swallows and some wren species. Each unit should be a separate box with its own entrance hole and floor. Before cutting, confirm the entrance size for your target species: a 1-1/2 inch hole suits most swallows, while a 1-1/8 inch hole is standard for chickadees and wrens. Plans from the Cornell Lab of Ornithology and state wildlife agencies list these sizes and are a good reference.
Shopping for one? See our guide: 3 Best Free Printable Octagon Birdhouse Plans Frees (2026): Our Picks.
Cut List and Materials
Use rough or nominal 3/4 inch cedar or pine, sanded and kept free of knots. Dimensions below assume a 6-unit stacked condo, with each compartment about 5-1/2 inches square inside.
| Part | Quantity | Size (inches) |
|---|---|---|
| Front and back panels | 2 | 8 x 36 |
| Side walls (divided) | 2 | 8 x 36 |
| Interior dividers | 2 | 7 x 7-1/2 |
| Compartment floors | 6 | 5-1/2 x 5-1/2 |
| Roof sections | 2 | 9 x 20 |
Add 3 inch deck screws or exterior-grade wood glue and brass or galvanized fasteners. Cut two 1/4 inch drain holes in each floor and add ventilation slots near the roof line.
Assembly Steps
- Cut all parts and mark the entrance holes on the front panel, centered 1-1/2 inches below the top of each compartment.
- Drill entrance holes with a forstner bit or hole saw, then roughen the area below each hole so chicks can climb out.
- Attach the interior dividers to the back panel with glue and screws, spacing them so each unit measures 5-1/2 inches square.
- Fasten the floors into each compartment, leaving a 1/4 inch gap at the sides for drainage.
- Assemble the side walls, then screw the front panel to the frame with pre-drilled holes to prevent splitting.
- Build the two-piece roof with a slight overhang, and attach it with hinges or screws so you can clean the units each fall.
Mounting the Condo
Mount the condo on a steel or aluminum pole at least 6 feet off the ground, with a predator guard or baffle below it. Face the entrances away from prevailing winds. Keep the site at least 40 feet from dense trees if you want swallows to use it.
Recommended gear
A forstner bit or hole saw set makes clean entrance holes without tearout. View on Amazon
Exterior wood glue and corrosion-resistant screws keep the joints solid through weather cycles. View on Amazon
A pilot drill bit set reduces splitting when you fasten thin cedar. View on Amazon
Common Mistakes
- Making every entrance hole the same size, which lets larger birds or starlings into smaller compartments.
- Leaving no drainage holes, so moisture builds up and nests mold.
- Using treated lumber or painted interiors that can harm nesting birds.
- Mounting the condo too low or in full sun, which overheats the units in summer.
- Skipping annual cleaning, which lets parasites build up between seasons.
If you want other starting points, compare these single-unit builds: Wood Birdhouse Plans Free: 6 Easy Builds With Cut Lists and Large Birdhouse Plans Free: 4 Builds for Owls, Kestrels and Wood Ducks. For colonial birds, Martin Birdhouse Plans Free: Build a Purple Martin House This Weekend covers a larger multi-room design.
FAQ
What entrance size should a birdhouse condo have?
Most swallows use a 1-1/2 inch entrance, while chickadees and wrens prefer 1-1/8 inch. Check your local species list before cutting.
Can I use pressure-treated lumber for a condo?
No. Chemical treatments can harm birds, so use untreated cedar, pine or other rot-resistant wood without finishes inside the compartments.
When should I clean out a birdhouse condo?
Clean each unit after the nesting season ends, usually in late summer or early fall, and wear a mask while removing old material.
Conclusion
With these birdhouse condo plans free, you can build a six-unit cedar structure in one weekend using standard tools. Match the entrance sizes to your target species, mount the condo high and in partial shade, and clean it every year. Your birds will thank you when the first families move in.
