Updated November 2026
Country church birdhouse plans give you a charming, traditional nest box that songbirds such as chickadees, nuthatches, and wrens will readily use. This guide walks you through a simple build with a cut list, assembly steps, and the dimensions that keep birds safe. You will finish with a weatherproof house that fits a yard, fence post, or porch rail.
Choose Your Dimensions and Materials
A church birdhouse works best with a steeple roof, a square body, and a small front entry. Plan for a floor of about 4 by 4 inches, walls around 8 inches tall, and a roof peak that sheds rain. Use rough-sawn cedar, pine, or cypress at least 3/4 inch thick. Untreated wood matters: paints, stains, and pressure-treated lumber can harm nesting birds, so keep the interior bare.
Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).
Cut and Assemble the Pieces
Cut all parts to the list below before you start assembly. Mark each piece with its name so nothing gets mixed up.
- Two front and back walls: 3/4 by 5-1/2 by 8 inches
- Two side walls: 3/4 by 3-1/2 by 8 inches (angle the top edges to meet the roof)
- Floor: 3/4 by 4 by 4 inches, with 4 drain holes of 1/4 inch
- Two roof panels: 3/4 by 5 by 6 inches, cut at a 30-degree bevel along one long edge
- Front entry hole: 1-1/8 inch diameter for chickadees, centered 6 inches above the floor
Assemble the walls first, using exterior wood glue and 1-5/8 inch galvanized or stainless exterior screws. Pre-drill every screw hole to prevent splitting. Attach the floor so it sits inset slightly, leaving drainage gaps at the corners. Fasten the roof panels so they overhang the walls by about 1 inch on each side.
Finish, Mount, and Maintain the House
Sand and Seal Safely
Sand the exterior with 120-grit paper and round over sharp edges. Leave the interior rough so young birds can grip the walls when they fledge. If you want protection, apply a clear water-repellent finish to the outside only, and let it cure fully before mounting.
Mount at the Right Height
Mount the house 5 to 10 feet off the ground, facing away from prevailing winds and direct afternoon sun. Use a predator guard or mount on a smooth pole. Clean out old nesting material each fall to prevent parasites from building up.
Common Mistakes
- Entry holes that are too large let starlings and house sparrows take over the box.
- Using painted or pressure-treated wood exposes birds to chemicals.
- Skipping floor drain holes lets water pool and rot the base.
- Mounting in full sun can overheat eggs and nestlings.
- Driving screws without pilot holes splits thin cedar.
Recommended Gear
A miter saw or hand saw with a fine-tooth blade gives clean, square cuts on the walls and roof bevels. Use a set of exterior-rated screws and galvanized hardware to resist weather. A spade or Forstner bit set in the 1-1/8 inch size makes an accurate entry hole.
- Exterior wood glue for stronger joints: View on Amazon
- Stainless steel exterior wood screws: View on Amazon
- Forstner bit set for clean entry holes: View on Amazon
Related Plans to Try Next
If you enjoy this style, compare the steps in Plans for a Church Birdhouse: A Step-by-Step Build With Cut List and Church Birdhouse Plans Free: 3 Builds With Cut Lists and Steps. For a smaller house, see Simple Cedar Birdhouse Plans: A Step-by-Step Build in One Weekend, and for a wren-sized option try Wren Birdhouse Plans Free: Build a Cedar House in One Weekend.
FAQ
What entry hole size works for a country church birdhouse?
A 1-1/8 inch hole suits chickadees and titmice, while wrens prefer about 1 inch. Keeping holes at these sizes helps exclude larger competing birds.
What wood is best for these plans?
Rough-sawn cedar is a common choice because it resists rot and stays lightweight. Untreated pine or cypress also works if it is kept unpainted inside.
When should I clean out the nest box?
Clean it in late fall or early winter after nesting season ends. Remove old material and check for mites or wasps before the next spring.
Conclusion
With a clean cut list, careful pilot holes, and the right entry size, these country church birdhouse plans produce a sturdy, bird-safe nest box. Mount it high, keep the interior unfinished, and clean it each year. Your local songbirds will thank you for it.
