Updated November 2026
Cub Scout birdhouse plans give a den a project that finishes in one session and sends every boy home with something he built himself. This guide covers a simple nest box sized for chickadees and wrens, a cut list cut from common lumber, and the assembly order that keeps the work safe and the box sturdy enough to last several seasons.
Choose the Right Size and Materials
Most Cub Scout dens build a single-room box with a 1-1/8-inch entrance hole, which suits chickadees, titmice, and wrens. Use 3/4-inch cedar, pine, or cypress boards that are rough or lightly planed on the outside. Avoid pressure-treated lumber, since the preservatives can harm birds, and skip painted or stained wood on the inside. Plan for a box roughly 4 inches square inside and 8 to 10 inches tall, with the floor set about 6 inches below the hole.
Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).
Cut List and Layout
Cut all parts from one 1×6 board about 6 feet long, plus a short piece for the roof. Mark the parts before cutting so every boy can see how the pieces fit together.
- Front and back: two pieces, 1/2 inch thick by 5-1/2 by 9 inches. Keep the taller edge for the roof line.
- Sides: two pieces, 3/4 inch by 4-1/2 by 9 inches.
- Floor: one piece, 3/4 inch by 4 by 4 inches, with drainage holes drilled in each corner.
- Roof: two pieces, 3/4 inch by 5 by 6 inches, cut at a slight angle so they overlap at the peak.
Drill the entrance hole in the front panel about 6 to 7 inches above the floor. Keep the hole centered and check it with a bit gauge before drilling.
Assembly Steps for a Den Build
- Pre-drill every screw location to prevent splitting. Use a 1/8-inch bit for the pilot holes.
- Attach the sides to the floor with exterior wood glue and two galvanized 1-1/4-inch screws per side.
- Attach the front and back panels, leaving the back slightly longer at the top so the roof sits flush.
- Fasten the roof pieces with hinged screws or a simple cleat so the box can be opened for cleaning.
- Leave a rough surface inside the front panel, or score it lightly, so fledglings can climb out.
- Let the glue cure overnight before mounting the box.
Mounting Height and Location
Mount the box 5 to 10 feet off the ground on a post or tree trunk that faces away from prevailing winds. Keep the entrance clear of branches that would give predators easy access.
Common Mistakes
- Using painted or pressure-treated wood, which can be toxic to nesting birds.
- Skipping drainage holes, which lets water collect and rot the floor.
- Drilling an entrance hole that is too large, inviting starlings or sparrows to take over.
- Driving screws without pilot holes, which splits thin cedar boards.
- Mounting the box where the afternoon sun heats the roof and interior.
Recommended Gear
- Exterior wood glue: Holds the joints while screws settle and resists moisture outdoors. View on Amazon
- Galvanized deck screws, 1-1/4 inch: Corrosion resistance matters for a box that will sit outside for years. View on Amazon
- Bit gauge for entrance holes: Lets each boy check hole diameter before drilling. View on Amazon
FAQ
What size entrance hole should a Cub Scout birdhouse have?
A 1-1/8-inch hole suits chickadees, titmice, and wrens. Larger holes can allow starlings and sparrows to move in and crowd out native species.
Can younger Scouts safely help with the build?
Yes, with adult supervision. Younger boys can sand, mark, and assemble with clamps, while adults handle the saw cuts and drilling.
When should the box be cleaned?
Clean the box after nesting season ends, usually late summer or early fall. Remove old nesting material and scrub with hot water only, never with bleach or harsh cleaners.
Conclusion
With one 1×6 board, a few screws, and an hour of focused work, a den can build a birdhouse that will host nesting birds for years. Follow the cut list, keep the entrance hole at the right size, and mount the finished box where predators and afternoon sun stay away. For more builds to try next, see our Wren Birdhouse Plans Free: Build a Cedar House in One Weekend and Plans for Wren Birdhouse: A Step-by-Step Guide With Cut List.
