Updated November 2026
Learning how to use a router to engrave wood comes down to three things: choosing the right bit, setting a shallow cutting depth, and guiding the router steadily along a pre-marked design. Done well, you end up with crisp lettering, monograms or decorative patterns on cutting boards, signs and furniture panels. This guide walks through the setup and the cut itself.
Choose the Right Bit and Router
For engraving, a small straight bit or a V-groove bit works best. A straight bit of 1/8 inch or 1/4 inch diameter cuts clean flat-bottomed lines, while a V-bit gives sharp, tapered grooves that suit lettering. A fixed-base router is the most controllable choice for hand work, and a plunge router lets you start and stop cuts precisely. For more on collet sizes and bit fit, see Wood Router 1/2 Inch Collet: How to Choose, Set Up and Use It (2026).
Shopping for one? See our guide: 5 Best Wood Router Prices: How Much Is a Wood Router? 5 Picks Compared.
Prepare the Workpiece and Design
Start with a flat, sanded board. Transfer your design using carbon paper, a printed template or a pencil outline. Clamp the workpiece firmly to a bench so nothing shifts during the cut. Engraving depth is usually between 1/32 inch and 1/8 inch, so keep the design simple enough that small letters remain readable.
Set Depth and Test on Scrap
- Install the bit and tighten the collet firmly, leaving the bit extended no more than necessary.
- Set the initial depth to about 1/32 inch.
- Make a test pass on a scrap board of the same species.
- Check the line width and depth, then adjust in small increments.
Working in several shallow passes is safer and gives cleaner edges than one deep cut. Many engravers increase depth by about 1/32 inch per pass until the desired line depth is reached.
Engrave the Design Step by Step
Turn the router on before the bit touches the wood, then lower it into the cut. Move the router in the direction that keeps the bit rotating against the feed, which reduces tear-out. Keep a steady speed and avoid pausing in one spot, since that burns the wood. Work around curves slowly and let the bit do the cutting rather than forcing it.
Handling Tight Curves and Lettering
On tight curves, slow your feed rate and take lighter passes. Lettering with serifs or sharp corners benefits from a V-bit, which can be guided into corners without leaving rounded ends.
Common Mistakes
- Cutting too deep in one pass, which causes burning and chatter.
- Skipping the test cut on scrap wood.
- Feeding the router against the bit rotation, which increases tear-out.
- Using a loose collet, which lets the bit wander.
- Engraving on an unsecured workpiece.
Recommended Gear
- Straight router bits for engraving: A small-diameter straight bit gives clean, flat-bottomed grooves for lettering and borders. View on Amazon
- V-groove router bits: These produce sharp, tapered lines well suited to lettering and detailed patterns. View on Amazon
- Router edge guide: An edge guide helps keep straight lines consistent when engraving borders. View on Amazon
FAQ
What is the best bit for engraving wood with a router?
A small straight bit or a V-groove bit is the most common choice. Straight bits suit flat-bottomed lines, while V-bits suit lettering and detailed work.
How deep should I engrave wood with a router?
Most engraving is done between 1/32 inch and 1/8 inch deep. Cut in several shallow passes rather than one deep cut.
Can I engrave wood with a router without a template?
Yes, you can freehand simple designs, but a printed template or carbon-transferred outline gives more consistent results. Practice on scrap wood first.
Conclusion
Engraving with a router rewards patience. Choose a suitable bit, set shallow depths, test on scrap and move steadily along your design. With practice, your lettering and patterns will become sharper and more consistent. If you are working with powered equipment, follow the manufacturer’s safety instructions and wear eye and hearing protection.
