Updated November 2026

Fence post birdhouse plans give you a simple way to turn a leftover cedar post into a durable nest box. You will cut one post section, add a front panel, roof and floor, and finish with a mounting method that keeps predators out. The whole build takes a weekend with basic hand and power tools.

Materials and Cut List

Use a 4×4 cedar or pressure-treated post cut to 10 inches for the body. Cedar holds up better to weather without paint, though you can paint the exterior if you prefer. Plan on about 4 inches of rot resistance as a minimum, so skip any post with heavy checking or soft spots.

Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).

  • Body: one 4×4 post, 10 inches long (actual dimensions about 3-1/2 inches square)
  • Front and back: already part of the post faces; trim the front face to size as needed
  • Roof: one 1×6 cedar board, 6 inches wide and 7 inches long, angled to shed water
  • Floor: one piece of 1/2-inch cedar, 4 x 4 inches
  • Hardware: exterior wood screws, a 1-1/4-inch hinge or screw-on roof for access

Step-by-Step Build

Start by marking the entry hole on the front face. For most small cavity nesters, a 1-1/8-inch hole suits chickadees and titmice, while a 1-1/2-inch hole works for bluebirds. Drill the hole about 6 inches above the floor so the nest stays dry and out of reach of ground predators.

Cut the Body and Set the Floor

Cut the post to 10 inches, then drill four or five 1/4-inch drainage holes in the floor, not the walls. Attach the floor with exterior screws driven from the outside, leaving a small gap for ventilation at the corners.

Attach the Roof

Mount the roof so it overhangs the front by about 1 inch. This overhang shields the entry from rain. A screw-on roof makes cleaning easier at the end of the season, so use two screws on each side rather than glue.

Mounting the Birdhouse on a Fence Post

Fence post birdhouse plans often fail at the mounting step, not the build. Mount the house with a backplate or bracket so it sits flush and stays level. Attach it to the top of the post or the side facing away from prevailing winds.

  1. Drill two pilot holes through the back of the house, sized for your mounting screws.
  2. Position the house at 5 to 6 feet off the ground, facing east or southeast if possible.
  3. Secure with galvanized screws or a stovepipe-style mount to block climbing predators.
  4. Check that the entry points straight out, not down toward the ground.

Common Mistakes to Avoid

  • Drilling the entry hole too large, which lets in starlings and house sparrows.
  • Skipping drainage holes, leading to damp nests and mold.
  • Mounting the house in full afternoon sun, which can overheat nestlings.
  • Using treated lumber with sealed coatings near the entry hole.
  • Forgetting a way to open the house for annual cleaning.

A drill with a sharp Forstner or spade bit gives clean entry holes without tearout on cedar. View on Amazon

Exterior-rated stainless or galvanized screws resist rust and keep the house from splitting over time. View on Amazon

A small hand saw or miter saw makes square, accurate cuts on the post and roof board. View on Amazon

FAQ

What size should the entry hole be?

Choose the hole size for the species you want. Around 1-1/8 inches suits chickadees and titmice, while bluebirds need about 1-1/2 inches.

Can I use pressure-treated wood?

You can, but avoid treated lumber that is recently treated or heavily coated, since birds may be harmed by chemicals. Untreated cedar is the safer choice for nest boxes.

When should I clean out the birdhouse?

Clean the house after the nesting season ends, usually in late summer or fall, to remove old nesting material and parasites. Consult a local wildlife or extension office if you have questions about a specific species.

Conclusion

These fence post birdhouse plans give you a practical nest box that uses one post and basic tools. Focus on the correct entry size, drainage, and a secure mount, and the house will last for many seasons. Start with a cedar post and a clear plan, and you will have a finished birdhouse by the end of the weekend.

Audrey Hayes

About Audrey Hayes

Audrey Hayes is part of our editorial team and reviews and edits our woodworking guides, checking product details against manufacturer specifications and owner feedback.