Updated November 2026
Red bellied woodpecker birdhouse plans are built around one goal: giving a large woodpecker a sturdy, drainable cavity with enough room to nest. This guide walks you through the dimensions, materials, and assembly steps so you can build a box in an afternoon. You will also learn where to mount it and what mistakes to avoid.
Start With the Right Dimensions
Red-bellied woodpeckers are bigger than most backyard cavity nesters, so a standard wren or bluebird box will not work. A typical red-bellied woodpecker box uses a floor of about 6 by 6 inches, an interior height of roughly 12 to 15 inches, and an entrance hole around 2 inches in diameter. Cavity depth matters too. Leave at least 8 inches from the entrance hole to the floor so the chicks are not pushed out too early.
Shopping for one? See our guide: 5 Best Birdhouses with License Plate Roof Plans for Backyard Builders (2026).
Choose Materials and Build the Box
Use rough-sawn or roughly 3/4-inch thick pine, cedar, or cypress. Thinner wood cracks and loses insulation quickly, while untreated exterior-grade material resists rot. Avoid pressure-treated lumber, since its chemicals are a concern for nesting birds. A basic cut list for a box that fits the dimensions above looks like this:
| Part | Quantity | Dimensions (inches) |
|---|---|---|
| Front and back | 2 | 6 x 18 |
| Sides | 2 | 6 x 15 |
| Floor | 1 | 6 x 6 |
| Roof | 1 | 8 x 9 |
- Cut all parts to the sizes above. Mark the entrance hole center on the front panel, about 12 inches up from the bottom edge.
- Drill the 2-inch entrance hole with a hole saw or Forstner bit.
- Drill four to six 1/4-inch drainage holes through the floor, and two to three ventilation holes near the top of each side.
- Assemble the sides, front, and back with exterior screws. Pre-drill to prevent splitting.
- Attach the floor so it sits just inside the walls and can be removed for cleaning. Add the roof with a slight overhang on the front.
- Score the interior walls horizontally with a saw kerf or rough the surface so chicks can climb out.
Mount the Box at the Right Height and Location
Mount the box 10 to 20 feet off the ground on a tree trunk or pole, ideally on the side facing away from prevailing winds. Position it in or near woodland edges with some open space nearby for foraging. Red-bellied woodpeckers often use dead or partially dead trees, so a box placed on a healthy tree with a little natural clutter nearby tends to attract attention. Check the box yearly, and clean out old nesting material after the season ends. Our Pileated Woodpecker Birdhouse Plans: A Step-by-Step Build Guide covers a larger cavity design if you have room for it.
Recommended gear
- Forstner bit set for clean entrance holes without tear-out. View on Amazon
- Exterior wood screws that resist rust and will not split thin cedar or pine. View on Amazon
- Circular saw with a fine-tooth blade for accurate, straight cuts on cedar boards. View on Amazon
Common mistakes
- Using an entrance hole that is too small, which can keep red-bellied woodpeckers from entering.
- Skipping drainage holes, leading to a damp, moldy floor.
- Painting or staining the interior, which can harm nesting birds.
- Mounting the box too low, where predators can reach it.
- Forgetting to remove old nest material before the next season.
FAQ
What size entrance hole does a red-bellied woodpecker need?
An entrance hole of about 2 inches in diameter is the standard size for this species. Smaller holes may exclude the birds, while larger ones invite predators and competitors.
Do red-bellied woodpeckers use birdhouses?
They do, though they often prefer natural cavities in dead or dying trees. A properly sized, well-mounted box in a suitable habitat can attract them.
When should I build and install the box?
Install the box in late winter or early spring, before nesting begins. Building it earlier gives you time to weather-test the joints and adjust the mounting location.
Conclusion
With the right dimensions, a sturdy build, and careful placement, a red bellied woodpecker birdhouse can serve for several seasons. Start with the cut list above, follow the steps in order, and check your box once a year. If you want to compare other designs first, browse our Woodpecker Birdhouse Plans Free: 5 Steps to a Safe Nest Box for related builds.
Related reading
- Red Headed Woodpecker Birdhouse Plans Free: 5-Step Build Guide
- Downy Woodpecker Birdhouse Plans: Build a Nest Box in One Afternoon
- Wren Birdhouse Plans PDF: A Step-by-Step Build With Cut List
- Wren Birdhouse Plans Free: Build a Cedar House in One Weekend
- Wood Birdhouse Plans Free: 6 Easy Builds With Cut Lists
